NZ PRODUCT GUIDE AUSTRALIAN OWNED & MANUFACTURED BGCINNOVADESIGN.CO.NZ

Transcription

1 NZ AUGUST 2012 AUSTRALIAN OWNED & MANUFACTURED BGCINNOVADESIGN.CO.NZ

2 INTRODUCING INNOVA INNOVA IS A RANGE OF INTERIOR LINING, EXTERIOR FACADE AND FLOORING PRODUCTS WHICH GIVE A NEW DIMENSION TO THE BGC PRODUCT RANGE. THE PRODUCTS WITHIN THE INNOVA RANGE HAVE BEEN DESIGNED TO INSPIRE YOU TO CREATE INNOVATIVE AND DYNAMIC DESIGNS WITHIN YOUR BUILDING OR RENOVATION PROJECT. PAGE 01

3 CONTENTS NULINE PLUS TM // 03 STRATUM TM // 04 DURAGRID TM // 05 DURAGROOVE TM // 06 DURASCAPE TM // 07 DURABARRIER TM // 08 BGC FIBRE CEMENT HAS BEEN TESTED AND IS DEEMED TO BE NON- COMBUSTIBLE. ALL 6MM OR THICKER BGC FIBRE CEMENT PRODUCTS HAVE 30 MIN FIRE RATING SEE INDIVIDUAL PRODUCT BROCHURES OR CONTACT BGC FOR SPECIFIC DETAILS. PAGE 02

4 NULINE PLUS IS A WEATHERBOARD- STYLE CLADDING SYSTEM. WITH ITS PERFECT JOIN AND A SEDUCTIVE LOOK THAT ECHOES REAL TIMBER, NULINE PLUS IS THE NATURAL EVOLUTION OF THE EVER-POPULAR NULINE WEATHERBOARD. THE NULINE PLUS TONGUE-&-GROOVE FITTING WILL DELIVER SEAMLESSLY CONSISTENT JOINS THROUGHOUT YOUR PROJECT. WITH ITS SLIGHT BEVEL ON THE REAR OF THE PLANK ALLOWING A 25MM BEARING FACE ON THE STUD, YOU LL FIND FIXING AND NAILING EXCEPTIONALLY EASY. / FACTORY SEALED & PRIMED, READY FOR PAINTING / QUICK, SIMPLE INSTALLATION: MANUAL NAILING, GUN NAILING OR SCREW FIXING / HIGHLY DURABLE: NO ROT OR DECAY / BRANZ APPRAISED NO.640 AND 641 (2015) WEATHERBOARDS TM WIDTH LENGTH 4200 ACCESSORIES PRODUCT Internal Corner Internal Obtuse Corner External Corner Aluminium Cavity Vent Strip 19mm Corner Soaker Aluminium or Stainless Steel Corner Soaker Aluminium or Stainless Steel Corner Soaker Aluminium or Stainless Steel Precut Scribers 150, 175 and 205mm BGC Edge Sealer LENGTH PAGE 03

5 A VIBRANT, INNOVATIVE ALTERNATIVE TO TRADITIONAL WEATHERBOARDS, STRATUM IS AN ENDLESSLY ADAPTABLE TRIO OF PLANK PRODUCTS. CHOOSE ONE STRATUM PROFILE AS A STANDALONE, OR MIX N MATCH TWO OR THREE TO CREATE EYE-CATCHING AND ORIGINAL INNOVA EXTERIOR CLADDING. STRATUM 300MM IS A WIDE PLANK WITH A 16MM HORIZONTAL JOINT; STRATUM DUO 300MM IS A WIDE PLANK WITH A 16MM CENTRE GROOVE AND THE LOOK OF TWO SLIMMER PLANKS; STRATUM TRIO 300MM WITH 2 16MM GROOVES CREATING A 3 PLANK EFFECT; STRATUM CONTOUR 170MM IS A SLIMMER PLANK WITH A 2MM REBATED SECTION AT THE TOP. / EASY SHIPLAP JOINING / FACTORY SEALED & PRIMED, READY FOR PAINTING / QUICK, SIMPLE INSTALLATION: MANUAL NAILING, GUN NAILING OR SCREW FIXING / BRANZ APPRAISED - STRATUM TM (NO.847) STRATUM TM CONTOUR (NO.848) STRATUM WEATHERBOARDS FINISH Stratum TM Stratum TM Duo Stratum TM Trio Stratum TM Contour WIDTH LENGTH 4200 ACCESSORIES PRODUCT Internal Corner - Stratum, Stratum Duo and Stratum Trio 12mm External Corner - Stratum, Stratum Duo and Stratum Trio 12mm Internal Corner - Stratum Contour 17mm External Corner - Stratum Contour 17mm J Jamb Flashing - Stratum, Stratum Duo and Stratum Trio J Jamb Flashing - Stratum Contour Cavity Vent Strip 19mm Closer 33mm - Stratum Contour Precut scribers 40 x 18mm - Stratum Precut scribers 40 x 18mm - Stratum Duo Precut scribers 40 x 18mm - Stratum Trio Precut scribers 40 x 18mm - Stratum Contour BGC Edge Sealer LENGTH PAGE 04

6 BGC S MARKET-LEADING FIBRE CEMENT SHEETING MAKES THE DURAGRID FAÇADE SYSTEM A WISE CHOICE FOR CLADDING EXTERIORS OF LOW TO MEDIUM-RISE CONSTRUCTION. EXTREMELY ROBUST AND HARDWEARING, DURAGRID WILL GIVE ANY BUILDING AN EXCITINGLY MODERN SHEEN. DURAGRID FACADE SYSTEM WITH ITS SMOOTH, FLAT SURFACE, A SQUARE- EDGE FINISH SIMPLY MADE FOR EXPRESSED JOINTING AND PANELS THAT WON T ROT, BURN OR CORRODE, DURAGRID ENABLES EASY DECORATION IN AN EXCITING VARIETY OF DESIGN FINISHES. / LIGHT, MODERN AND HIGHLY DURABLE / CAN BE USED IN WIND ZONES UP TO AND INCLUDING EXTRA HIGH (NZS3604:2011) / PERFECT FOR A RANGE OF FINISHES FROM PAINTED TO TEXTURED COATINGS / UNAFFECTED BY, AIR, STEAM, SALT OR SUNLIGHT / QUICK, SIMPLE BRAD INSTALLATION / BRANZ APPRAISED NO. 752 (2011) WIDTH LENGTH ACCESSORIES PRODUCT Horizontal Backing Strip Cavity Vent Strip - 19mm BGC Edge Sealer LENGTH PAGE 05

7 FOR UP-TO-THE-MINUTE EXTERIORS OR INTERIORS, CHOOSE DURAGROOVE CLADDING. A PEERLESSLY ADAPTABLE, VERTICALLY-GROOVED PANEL AVAILABLE IN DIFFERENT PROFILES AND SPACING, DURAGROOVE HAS A SHIPLAP JOIN TO EASE AND SPEED YOUR INSTALLATION. DURAGROOVE FACADE SYSTEM SPECIFY DURAGROOVE FOR SINGLE-STOREY AND MEDIUM-HEIGHT PROJECTS. DURAGROOVE COMES IN THREE VARIANTS: SMOOTH WIDE (150MM); SMOOTH EXTRA WIDE (400MM); SMOOTH NARROW (100MM); AND WOODGRAIN WIDE (150MM). / VERTICAL GROOVES EXCITINGLY CONTEMPORARY ALTERNATIVE TO TRADITIONAL WEATHERBOARD / LIGHT AND DURABLE / ACRYLIC SEALED PANELS AID PAINT APPLICATION / QUICK TO INSTALL NO NEED FOR TAPED AND FILLED JOINTS / PANELS RESISTANT TO AIR, STEAM, SALT AND SUNLIGHT / BRANZ APPRAISED NO. 799 AND 798 (2013) 9 FINISH Smooth Narrow Smooth Wide Smooth Extra Wide Woodgrain 13.5 WIDTH 1200 LENGTH ACCESSORIES PRODUCT Internal Corner External Corner Horizontal h Flashing Cavity Vent Strip - 19mm BGC Edge Sealer LENGTH PAGE 06

8 DURASCAPE IS A 9MM-THICK BASE SHEET. EXCELLENT FOR COVERING LARGE AREAS, ITS 5MM WIDE SHIPLAP JOINT GIVES THE SHEET A SUBTLE VERTICAL SHADOW LINE. TO CREATE AN APPEALINGLY RENDERED LOOK, TRY FINISHING DURASCAPE ONSITE WITH A ROLL-ON TEXTURED PAINT. DURASCAPE FACADE SYSTEM / LIGHT AND DURABLE / IDEAL FOR SINGLE-STOREY AND MEDIUM HEIGHT INSTALLATIONS WHERE YOU WANT LARGE PANELS / QUICK INSTALLATION NO NEED FOR TAPED AND FILLED JOINTS / PANELS UNAFFECTED BY AIR, STEAM, SALT AND SUNLIGHT / CAN BE FINISHED IN A RANGE OF DECORATIVE COATINGS / BRANZ APPRAISED NO. 799 AND 798 (2013) WIDTH LENGTH ACCESSORIES PRODUCT Internal Corner External Corner Horizontal h Flashing Cavity Vent Strip -19mm BGC Edge Sealer LENGTH PAGE 07

9 DURABARRIER IS A RIGID SHEATHING/ AIR BARRIER FOR ALL TYPES OF RESI- DENTIAL AND COMMERCIAL TIMBER- FRAMED OR STEEL FRAMED BUILDINGS. DURABARRIER RESISTS HIGH WINDS BY EQUALISING AIR PRESSURE WITHIN THE CAVITY TO EXTERNAL CONDITIONS. DURABARRIER CAN BE CHOSEN AS EITHER A 4.5MM OR 6MM-THICK FIBRE CEMENT SHEET, SEALED ON THE FACE AND EDGES AND SPECIALLY MANUFACTURED FOR USE AS A RIGID SHEATHING. DURABARRIER RIGID SHEATHING / AIR BARRIER / LIGHT AND DURABLE / CORRECT INSTALLATION WILL ENSURE RESISTANCE TO MOISTURE DAMAGE AND ROT / SUITABLE FOR UP TO THE EXTRA HIGH WIND ZONE OR UP TO 2.5KPA (ULS) FOR SPECIFIC DESIGN / FACE-SEALED TO RAPIDLY DISPLACE MOISTURE / PROVIDES SHORT TERM WEATHERTIGHTNESS / TEMPORARILY SECURES BUILDINGS AHEAD OF CLADDING / BRANZ APPRAISED (NO 721, 2011) AND TESTED AGAINST TABLE 23, NZBC ACCEPTABLE SOLUTION E2/AS WIDTH 1200 LENGTH PAGE 08

10 WARRANTY BGC Fibre Cement (NZ) warrants its products to be free from defects caused by defective materials or workmanship (manufacturer) for a period of 15 years (Nuline TM Plus 25 years) or 50 years for bracing sheets from the date of purchase, subject to the conditions set out below. Further, BGC Fibre Cement (NZ) warrants its products to be resistant from rotting, fire and cracking so long as the installation is carried out in accordance with BGC Fibre Cement literature available at the time of purchase. i) This warranty is non transferable. ii) The product must be installed and maintained in accordance with the relevant BGC Fibre Cement (NZ) literature current and available at the time of purchase. All additional products including accessories, jointing systems and coatings used in conjunction with the BGC Fibre Cement product(s) must be applied or installed according to the appropriate manufacturer s instructions. iii) BGC Fibre Cement (NZ) is not liable for any breach of warranty unless the claimant provides proof of purchase and a claim is submitted in writing within 30 days of the defect becoming evident. If the defect is detected prior to installation, the claim must be submitted before installation occurs. iv) If BGC Fibre Cement (NZ) products are found to be defective, BGC Fibre Cement will at its option, repair or replace the product, supply equivalent replacement products or reimburse the purchase price of the product. v) BGC Fibre Cement (NZ) shall not be liable for any damage or losses (direct or indirect) including property damage or personal injury, economic loss or loss of profits, consequential loss arising in contract or negligence or howsoever arising. BGC Fibre Cement (NZ) shall not be liable for any claims, damages or defects arising from or attributed to poor workmanship, poor design or detailing, settlement or structural movement or movement of materials to which the product is attached, incorrect design of the structure, acts of God, including but not limited to floods, cyclones, earthquakes or severe weather or unusual climate conditions, performance of coatings or paints applied to the product, normal wear and tear, growth of mould, mildew, fungi, bacteria or any other organism on the products surface (exposed or unexposed). vi) The project must be designed and constructed in accordance with all relevant requirements of the current New Zealand Building Code regulations and standards. vii) If satisfying a claim under this warranty which involves recoating or painting of BGC Fibre Cement (NZ) products, there may be slight colour differences between the replacement product and the original products due to the effect weathering and variations in materials over time. viii) All warranties, conditions, liabilities and obligations other than those specified in this warranty are excluded to the fullest extend allowed by the law. PAGE 09

11 CONTACT TO CONTACT YOUR NEAREST BGC STOCKIST, PLEASE CALL: ADELAIDE BRISBANE MELBOURNE PERTH SYDNEY NEW ZEALAND FREE PHONE BGC FIBRE CEMENT IS A PROUD AUSTRALIAN OWNED MANUFACTURER OF FIBRE CEMENT PRODUCTS. BGC FIBRE CEMENT PROVIDES BUILDERS, DEVELOPERS AND ARCHITECTS WITH A RANGE OF DESIGN ALTERNATIVES AND INNOVATIVE PRODUCTS, SUCH AS: EXTERIOR PRODUCTS AND APPLICATIONS INNOVA RANGE OF PRODUCTS DURAGRID TM / A light weight facade giving a modern and durable finish. DURAGROOVE TM / A vertically grooved exterior facade panel. DURASCAPE TM / A lightweight exterior facade base sheet with a subtle vertical shadow line. NULINE TM PLUS / A weatherboard style cladding system. STRATUM TM / Is a trio of plank products, each of which can be used as stand alone products or used together to create a striking exterior cladding solution. DURABARRIER TM / A rigid sheathing/air barrier for all types of timber framed construction. EXTERIOR PRODUCTS AND APPLICATIONS BGC FIBRE CEMENT RANGE OF PRODUCTS DURASHEET TM / Ideal for the cladding of gables and lining of eaves. Can also be used on commercial soffits and cladding on non impact areas. DURAPLANK TM / Available in Smooth and Woodgrain finishes, Duraplank TM is ideal for exterior cladding of upper storey conversions or ground level extensions. COMPRESSED / Used for domestic, commercial sheet for wet areas, flooring, partitions, exterior decking, fascia and facade cladding. DURAFLOOR TM / Is the ultimate fl ooring product that can be used in both interior and exterior applications. DURALUX TM / Suitable for exterior applications where it will be sheltered from direct weather. DURACOM TM / A compressed fibre cement facade system. STONESHEET TM / Purpose designed substrate for stone tile facade. INTERIOR PRODUCTS AND APPLICATIONS DURALUX PLUS TM / An interior lining board suitable for ceilings and soffits. DURAFLOOR TM / Is the ultimate fl ooring product that can be used in both interior and exterior applications. DURALINER PLUS TM / An interior lining board, this is the perfect substrate for tiles and is ideal for wet areas. CERAMIC TILE UNDERLAY / A substrate for ceramic and slate floor tiles. AUSTRALIAN OWNED & MANUFACTURED BGCINNOVADESIGN.COM.AU DESIGN THESHAPEGROUP.COM.AU