MATERIAL SAFETY DATA SHEET (According to EC Commission Directive 2001/58/EC)

Transcription

1 1.- Product Name Registered name: Description: Anticorrosive pigment preparation Manufacturer: NUBIOLA GRUPO Head Office: Gran Vía Corts Catalanes BARCELONA Telephone: Emergency Information: UK National Poisons Emergency Composition / Information on Ingredients Chemical Characterization: Calcium and Strontium Phosphosilicate based preparation. Components are not classified as dangerous, so there are not subjected to any special labelling according to Directive 67/548/EC and its last amendment, Directive 2004/73/EC Hazards Identification There are no hazardous ingredients as defined by Directive 67/548/EC and its amendments First Aid Measures General Advice: Take off contaminated clothes After inhalation: Take the victim into the fresh air. After skin contact: Flush away with soap and water and rinse. After eye contact: Flush eyes with plenty of water (10-15 min.). After accidental ingestion. Rinse mouth with water. Call a physician. Page 1 of 5

2 5.- Fire-fighting Measures Not flammable product. Suitable extinguishing media Water, foam, CO 2 or powder extinguisher. Special risk posed by the substance or by the actual preparation, its combustion products or gases discharged Above 1100 ºC, strontium, phosphorous, calcium and silicium oxides may be released. Special protective equipments When extinguishing fires, use breathing apparatus with an independent source of air Accidental Realease Measures Personal Precautions Avoid dust development. (See sections 7 and 8) Environmental Precautions Do not empty into drains, rivers, lakes or sewages. Collect under wet conditions Handling and Storage Handling Avoid breathing dust and use with adequate ventilation. Requirements to be met by storerooms and containers Keep containers tightly sealed. Store in a roofed and dry place at room temperature. Page 2 of 5

3 8. - Exposure Controls and Personal Protection Additional information about engineering measures No special measures must be observed. Provision is required to keep exposure below permissible limit (<10 mg/m 3 ). Personal protective equipment If workplace limits are exceeded, a gas mask approved for this particular job must be worn: Filter P2 (Solid and liquid particles) (DIN 3181) 9. - Physical and Chemical Properties Form: Powder Colour: White Odour: Odourless ph: (in 100 g/l water) Loss of Ignition: 4-6 % Explosive properties The material is not explosive Solubility: - In water Insoluble - In solvents Insoluble Density (20 C): 3.02 g/cm Stability and Reactivity This product might decompose above 1000 C producing strontium phosphorous, calcium and silicium oxides. Highly acidic liquids may dissolve it partially. Page 3 of 5

4 11. - Toxicological Information No toxic in small quantities. Avoid long exposure to high quantities of dust Ecological Information No ecotoxicological data available Disposal Consideration Product In accordance with local official regulations pass on to an appropriate waste dump. Contaminated packaging Dispose empty packaging in accordance with all local, state, and Federal requirements Transport Information Not classified as hazardous under transport regulations. Page 4 of 5

5 15. - Regulatory Information Preparation not classified as dangerous according to Commission Directive 2001/60/EC, adapting to technical progress Directive 1999/45/EC of the European Parliament and of the Council Further Information Restricted to professional users. Nubiola can only guarantee those certified parameters in the Specification Data Sheet of our products. Nubiola is not responsible for any misuse and/or inappropriate handling or storing conditions that may act to the detriment of certified specifications of our products or pose a risk to human health or the environment. Due to the fact that there are multitudes of formulations, manufacturing processes and end uses, Nubiola strongly recommends that customers perform previous tests under their own testing program and carry out appropriate verifications in order to determine the ultimate suitability of our products and observe existing laws and legislation. Modifications to previous issue --- Page 5 of 5