MATERIAL SAFETY DATA SHEET KUUS INC. KNOCK DOWN PROFESSIONAL HORNET AND WASP KILLER BLASTER FOAM Effective Date: April 1, 2015

Size: px

Start display at page:

Download "MATERIAL SAFETY DATA SHEET KUUS INC. KNOCK DOWN PROFESSIONAL HORNET AND WASP KILLER BLASTER FOAM Effective Date: April 1, 2015"

Lynne Terry
5 years ago
Views:

1 MATERIAL SAFETY DATA SHEET KNOCK DOWN PROFESSIONAL HORNET AND WASP KILLER BLASTER FOAM Effective Date: April 1, MATERIAL IDENTIFICATION AND USE MANUFACTURER S NAME MANUFACTURER S ADDRESS 450 TAPSCOTT ROAD, UNIT 5 & 6 SCARBOROUGH, ONTARIO M1B 1Y4 MANUFACTURER S TELEPHONE NO SUPPLIER IDENTIFIER SUPPLIER S ADDRESS SUPPLIER S TELEPHONE NO. PRODUCT IDENTIFIER PRODUCT CODE PRODUCT USE KNOCK DOWN PROFESSIONAL HORNET AND WASP KILLER BLASTER FOAM FORMULA: DOMESTIC KD130P INSECTICIDE 2. HAZARDOUS INDGREDIENTS OF MATERIALS INGREDIENTS PERCENTAGE (%) CAS NUMBER: LD50(species/route) LD50(species/route) D-Trans Allethrin mg/kg (oral-rat) 2.51mg/l or air (inhal-rat) Permethrin >2500mg/kg (oral-rat) Not Available N-Octyl Bicycloheptene Bicarboximide mg/kg (oral-rat) 4080mg/l (inhal-rat) Ethanol mg/kg (oral-rat) 31623ppm/4h (inhal-rat) Isobutane Not Applicable ppm/4h (inhal-rat) Propane >5000 mg/kg Not Available Dermal-rabbits 3. PHYSICAL DATA FOR PRODUCT PHYSICAL STATE ODOUR AND APPEARANCE AEROSOL OFF-WHITE EMULSION. FRAGRANT. VAPOUR PRESSURE (mm Hg) at 20 C SPECIFIC GRAVITY EVAPORATION RATE (N-BUTYL ACETATE=1): GREATER THAN 1

2 VAPOUR DENSITY (AIR=1): GREATER THAN 1 % VOLATILE (BY WEIGHT): BOILING POINT C SOLUBILITY IN WATER (20 C) FIRE AND EXPLOSION HAZARD OF PRODUCT EXTINGUISHING MEDIA WATER, CARBON DIOXIDE, DRY CHEMICAL, FOAM. FLASHPOINT 13 C UPPER EXPLOSION LIMIT (% BY VOL) 19.0 LOWER EXPLOSION LIMIT (% BY VOL) 1.9 SPECIAL PROCEDURES FULL PROTECTIVE EQUIPMENT INCLUDING SELF CONTAINED BREATHING APPARTATUS SHOULD BE WORN. 5. REACTIVITY DATA CHEMICAL STABILITY HAZARDOUS POLYMERIZATION INCOMPATIBLE MATERIALS HAZARDOUS DECOMPOSITION PRODUCTS STABLE WILL NOT OCCUR STRONG OXIDIZING AGENTS HYDROCARBON FUMES AND SMOKE. CARBON MONOXIDE WHERE COMBUSTION IS INCOMPLETE. 6. TOXICOLOGICAL PROPERTIES OF PRODUCT SHORT TERM EFFECTS OF EXPOSURE ROUTE OF ENTRY SKIN CONTACT EYE CONTACT ACUTE EFFECTS INGESTION ACUTE EFFECTS SKIN CONTACT ACUTE EFFECTS INHALATION ACUTE EFFECTS EYE YES YES HEADACHE, NAUSEA, VOMITING AND WEAKNESS FREQUENT OR PROLONGED CONTACT MAY IRRITATE THE SKIN. INHALATION OF SOLVENTS MAY CAUSE IRRITATION. PROPELLANT IS A SIMPLE ASPHYXIANT. FREQUENT OR PROLONGED CONTACT MAY IRRITATE THE EYES.

3 7. TOXICOLOGICAL PROPERTIES OF PRODUCT (CONT D) LONG TERM EFFECTS OF EXPOSURE EFFECTS OF CHRONIC EXPOSURE TARGET ORGANS SOLVENTS MAY CAUSE DEFATTING DERMATITIS SPECIAL HEALTH EFFECTS CARCINOGINICITY NO 8. PREVENTIVE MEASURES CONDITIONS UNDER WHICH PPE REQ D EYE PROTECTION REQUIREMENTS GLOVE REQUIREMENTS CLOTHING REQUIREMENTS RESPIRATOR REQUIREMENTS ENGINEERING CONTROLS REQUIRED SPILL AND LEAK PROCEDURES WASTE DISPOSAL METHODS STORAGE TEMPERATURE HANDLING/STORAGE NORMAL WORK CONDITIONS NONE REQUIRED FOR NORMAL USAGE. WEAR SAFETY GLASSES WEAR CHEMICAL RESISTANT GLOVES NOT NORMALLY REQUIRED IF USED INDOORS ON A CONTINUOUS BASIS, USE OF CARTRIDGE TYPE RESPIRATOR IS RECOMMENDED. VENTILATION REMOVE ALL SOURCES OF IGNITION. USE AN INERT ABSORBENT MATERIAL, AND NON-SPARKING TOOLS. VENTILATE AREA. PREVENT FROM ENTERING A WATERCOURSE. DO NOT PUNCTURE OR INCINERATE CONTAINERS, EVEN WHEN EMPTY. DISPOSE OF IN ACCORDANCE WITH LOCAL, PROVINCIAL, AND FEDERAL REGULATIONS. AMBIENT KEEP AWAY FROM HEAT, SPARKS, AND OPEN FLAMES. STORE IN COOL, WELL VENTILATED AREA NOT TO EXCEED 50 C. 9. FIRST AID MEASURES INGESTION SKIN CONTACT INHALATION IF SWALLOWED, DO NOT INDUCE VOMITING, GET MEDICAL ATTENTION. WASH THOROUGHLY WITH SOAP AND WATER. IF INHALATION OR VAPOUR OR SPRAY MIST, REMOVE TO FRESH AIR.

4 10. FIRST AID MEASURES EYE FLUSH IMMEDIATELY WITH PLENTY OF WATER FOR AT LEAST 15 MINUTES AND GET MEDICAL ATTENTION. 11. REGULATORY INFORMATION CANADIAN REGULATIONS: WHMIS CLASSIFICATION NOT REGULATED BY WHMIS. CNFC SECTION LEVEL 1. CEPA (Canadian Environmental Protection Act) U.S. REGULATIONS: HMIS RATING HEALTH HMIS RATING FLAMMABILITY HMIS RATING REACTIVITY 2 MODERATE HAZARD. 1 SLIGHT HAZARD. 0 MINIMAL HAZARD. HMIS RATING PERSONAL PROTECTION B. NFPA CODE 30B LEVEL 1. SARA 313 INFORMATION: CALIFORNIA PROPOSITION 65: TSCA (Toxic Substances Control Act) ALL SUBSTANCES IN THIS PRODUCT ARE LISTED ON THE CANADIAN DOMESTIC SUBSTANCES LIST (DSL) OR ARE NOT REQUIRED TO BE LISTED. THIS PRODUCT CONTAINS THE FOLLOWING SUBSTANCES SUBJECT TO THE REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III OF THE SUPERFUND AMENDMENTS AND REAUTHORIZATION ACT OF 1986 AND 40 CFR PART 372:. CAS #: CHEMICAL NAME:. * PERMETHRIN. THE FOLLOWING STATEMENT IS MADE IN ORDER TO COMPLY WITH THE CALIFORNIA SAFE DRINKING WATER AND TOXIC ENFORCEMENT ACT OF 1986:. WARNING: THIS PRODUCT DOES NOT INTENTIONALLY CONTAIN ANY CHEMICALS KNOWN TO THE STATE OF CALIFORNIA TO CAUSE CANCER, BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM. CAS #: CHEMICAL NAME: N/A. ALL COMPONENT OF THIS PRODUCT ARE LISTED ON THE TSCA INVENTORY. ANY IMPURITIES PRESENT IN THIS PRODUCT ARE EXEMPT ROM LISTING. VOC (w/w%) TRANSPORTATION INFORMATION T.D.G. CLASSIFICATION CONSUMER COMMODITY (AEROSOLS, UN1950, CLASS 2.1). D.O.T. CLASSIFICATION CONSUMER COMMODITY, ORM-D.

5 13. PREPARATION DATE OF MATERIAL SAFETY DATA SHEET PREPARED BY TELEPHONE NUMBER OF PREPARER DATE PREPARED April 1, 2015 THE INFORMATION CONTAINED HEREIN IS OFFERED ONLY AS A GUIDE TO THE HANDLING OF THIS SPECIFIC MATERIAL AND HAS BEEN PREPARED IN GOOD FAITH BY TECHNICALLY KNOWLEDGEABLE PERSONNEL. IT IS NOT INTENDED TO BE ALL-INCLUSIVE AND THE MANNER AND CONDITIONS OF USE AND HANDLING MAY INVOLVE OTHER ADDITIONAL CONSIDERATIONS. NO WARRANTY OF ANY KIND IS GIVEN OR IMPLIED AND KUUSPORT MANUFACTURING LIMITED WILL NOT BE LIABLE FOR ANY DAMAGES, LOSSES, INJURIES OR CONSEQUENTIAL DAMAGES WHICH MAY RESULT FROM THE USE OR RELIANCE ON ANY INFORMATION CONTAINED HEREIN.

MATERIAL SAFETY DATA SHEET Lloyds Laboratories Inc. Cold Galvanizing Zinc Rich Primer (Aerosol) Part # 21214

MATERIAL SAFETY DATA SHEET Lloyds Laboratories Inc. Cold Galvanizing Zinc Rich Primer (Aerosol) Part # 21214 SECTION 1: PRODUCT AND COMPANY IDENTIFICATION PRODUCT NAME: Cold Galvanizing Zinc Rich Primer PRODUCT USE: Coating. MANUFACTURER; SUPPLIER: ADDRESS: 613 Neal Drive, Peterborough, Ontario, K9J 6X7 ADDRESS: