1 3M AUSTRALIA PTY LIMITED 3M NEW ZEALAND LTD Pacific Highway 250 Archers Road 3 Pymble NSW 2073 Glenfield Auckland N.Z.

Transcription

1 1 3M AUSTRALIA PTY LIMITED 3M NEW ZEALAND LTD Pacific Highway 250 Archers Road 3 Pymble NSW 2073 Glenfield Auckland N.Z. 4 Phone: Phone: (9) HR EMERGENCY: (Australia only) ======================================================================= ===== 9 MATERIAL SAFETY DATA SHEET 10 ======================================================================= ===== Document ID : Issue date : 29/09/ Version : 3.02 Supersedes date : 08/12/ Document status : Issued This MSDS has been prepared by 3M Australia Pty Ltd Toxicology Dept PRODUCT AND COMPANY IDENTIFICATION PRODUCT NAME 24 HIPA CLEAN DIVISION 27 INTERNATIONAL OUS STAFF SERVICES M Product ID 30 XA , AS , AS , RECOMMENDED USE: Aerosol solvent to clean surfaces prior to the 33 application of a 3M tape or adhesive HAZARDS IDENTIFICATION NOTE: HAZARDOUS SUBSTANCE. DANGEROUS GOODS POISONS SCHEDULE 42 Not a scheduled poison according to the criteria of SUSDP Symbols 45 F+ (Extremely Flammable) 46 Xi (Irritant) Risk Codes and Phrases 50 R12 Extremely flammable. 51 R36 Irritating to eyes. 52 R67 Vapours may cause drowsiness and dizziness Safety Codes and Phrases 56 S15 Keep away from heat. S16 Keep away from sources of ignition - No 57 smoking. Avoid using with or near equipment that may produce sparks.

2 58 S23C Do not breathe vapour or spray. S51 Use only in well ventilated 59 areas. S24/25 Avoid contact with the skin and eyes. S26 In case of 60 contact with eyes, rinse immediately with plenty of water and seek 61 medical advice. S28A After contact with skin, wash immediately with 62 plenty of soap and water. 3M S2017 WARNING! Pressurised container. 63 Protect from sunlight and do not expose to temperatures exceeding 64 50C. Do not pierce or burn, even after use. Do not spray on a naked 65 flame or incandescent material. S2 Keep out of the reach of children FF COMPOSITION Ingredient Name CAS number Percentage ISOPROPYL ALCOHOL BUTANE < PROPANE < FIRST AID MEASURES EYE CONTACT 85 Immediately flush eyes with large amounts of water. Get immediate 86 medical attention SKIN CONTACT 89 Wash affected area with soap and plenty of water INHALATION 92 If signs/symptoms occur, remove person to fresh air. If 93 signs/symptoms continue, seek medical attention IF SWALLOWED 96 Do not induce vomiting. Drink two glasses of water. Call a doctor FIRE FIGHTING MEASURES SUITABLE EXTINGUISHING MEDIA 103 Water spray. Carbon dioxide. Dry chemical. Alcohol-type foam EXPOSURE HAZARDS DURING FIRE 106 Closed containers exposed to heat from fire may build pressure and 107 explode. Vapours may travel long distances along the ground or floor 108 to an ignition source and flash back FIRE FIGHTING PROCEDURES 111 Wear full protective clothing, including helmet, self-contained, 112 positive pressure or pressure demand breathing apparatus, turnout 113 gear, bands around arms, waist and legs, face mask, and protective 114 covering for exposed areas of the head. Water may not effectively 115 extinguish fire; however, it should be used to keep fire-exposed 116 containers and surfaces cool and prevent explosive rupture. For leaks 117 or spills which have not ignited, water spray can be used to disperse 118 the flammable vapour and protect personnel attempting to stop the

3 119 leak Combustion Products from Fire 122 Combustion Products from Fire are listed in Section 10, STABILITY AND 123 REACTIVITY HAZCHEM CODE 2YE FF ACCIDENTAL RELEASE MEASURES (SPILL) Personal Precautions 135 Observe precautions from other sections Spill Response 138 Ventilate area with fresh air. Remove all ignition sources such as 139 flames, smoking materials, and electrical spark sources. Use only 140 non-sparking tools. Contain spill. Cover with absorbent material. 141 Clean up residue. Place in an approved metal container HANDLING AND STORAGE Incompatibility - Materials to Avoid 148 Store away from heat. Store out of direct sunlight Fire Avoidance 151 Aerosol container contains flammable gas under pressure. No smoking 152 while handling this material. Do not spray near flames or sources of 153 ignition Explosion Avoidance 156 Keep away from heat, sparks, open flame, pilot lights and other 157 sources of ignition. Vapours may ignite explosively Precautions for Safe Handling 160 Do not pierce or burn containers, even after use Conditions for Safe Storage 163 Store at temperatures below 49 degrees C EXPOSURE CONTROLS/PERSONAL PROTECTION ISOPROPYL ALCOHOL ( ) 170 NATIONAL EXPOSURE STANDARDS: TWA: 400ppm, 983mg/m3. STEL: 500ppm, mg/m BUTANE ( ) 173 NATIONAL EXPOSURE STANDARDS: TWA: 800ppm, 1900mg/m PROPANE ( ) 175 NATIONAL EXPOSURE STANDARDS: Asphyxiant Special Information, Exposure/Protection 178 The extent to which the following recommendations for exposure 179 control and protection are observed should depend on the risk

4 180 assessment undertaken for the specific conditions under which this 181 product is used, including occupational hygiene measurements Recommended Ventilation 184 Use in a well ventilated area. Do not use in confined areas or areas 185 with little or no air movement. If possible, use outdoors. Not 186 recommended for interior use on large surface areas Eye Protection 189 Avoid eye contact with vapours, mists or spray Skin Protection FF 195 Avoid prolonged or repeated skin contact Respiratory Protection 198 Avoid prolonged breathing of vapours. Avoid prolonged breathing of 199 spray or mists Prevention of Accidental Ingestion 202 Do not ingest. Keep out of the reach of children PHYSICAL/CHEMICAL PROPERTIES Appearance and Odour Liquid aerosol spray; isopropanol 209 odour ph Not applicable Boiling point 82 C Melting point Not determined Flash point < 0 C Autoignition temperature Not determined Vapour pressure Not determined Water Solubility Not determined Specific gravity Vapour density 2.1 (Air=1) Volatile organic compounds (VOC) Not determined 230 content Evaporation rate Not determined Viscosity Not determined Flammable Limits - LEL 2 % Flammable Limits - UEL 12 %

5 STABILITY AND REACTIVITY Materials to Avoid 245 Heat Hazardous Decomposition Products 248 Carbon Monoxide and Carbon Dioxide. Hydrogen Fluoride. Aldehydes. 249 Toxic Vapours, Gases or Particles Stability 252 Stable. Hazardous polymerisation will not occur FF TOXICOLOGICAL INFORMATION Effects from Eye Contact 262 Moderate Eye Irritation: Signs/symptoms can include redness, swelling, 263 pain, tearing and blurred or hazy vision Effects from Skin Contact 266 Mild Skin Irritation: Signs/symptoms may include localised redness, 267 swelling, and itching Effects from Inhalation 270 Intentional concentration and inhalation can be harmful or fatal. 271 Single overexposure, above recommended guidelines, may cause: Central 272 Nervous System Depression: Signs/symptoms can include headache, 273 dizziness, drowsiness, lack of coordination, slowed reaction time, 274 slurred speech, giddiness and unconsciousness. Lower Respiratory 275 Tract Irritation: Sign/symptoms may include cough, sore throat, 276 chest tightness, and shortness of breath Effects from Ingestion 279 Ingestion is not a likely route of exposure to this product. 280 Ingestion may cause: 281 Gastrointestinal Irritation: Signs/symptoms may include abdominal 282 pain, nausea, diarrhoea and vomiting. 283 Central Nervous System Depression: Signs/symptoms can include 284 headache, dizziness, drowsiness, muscular weakness, incoordination, 285 slowed reaction time, fatigue, blurred vision, slurred speech, 286 giddiness, tremors and convulsions ECOLOGICAL INFORMATION Other Effects and Information 294 No data available. Since regulations vary, consult applicable 295 regulations or authorities before disposal DISPOSAL CONSIDERATIONS Product after Use

6 302 Do not puncture or burn cans in a household incinerator Methods for Disposal 305 Incinerate in a permitted hazardous waste incinerator. Disposal 306 facilities must be capable of handling aerosol cans. Combustion 307 products will include HF. Facility must be capable of handling 308 halogenated materials. Dispose of empty product containers in a 309 sanitary landfill. Dispose of completely absorbed waste product in a 310 facility permitted to accept chemical wastes Special Instructions for Disposal 313 If an aerosol can recycling program is available, evacuate can 314 completely prior to disposal. Incinerate in a permitted hazardous 315 waste incinerator. Disposal facilities must be capable of handling 316 aerosol cans. Combustion products will include HF. Facility must be 317 capable of handling halogenated materials. Dispose of empty product 318 containers in a sanitary landfill. Dispose of completely absorbed FF 322 waste product in a facility permitted to accept chemical wastes. 323 Contact your local waste authority to determine suitable disposal 324 methods TRANSPORT INFORMATION ADG (Road/Rail) UN NUMBER UN PROPER SHIPPING NAME AEROSOLS DANGEROUS GOODS CLASS SUBSIDIARY RISK NONE ALLOCATED PACKING GROUP NOT APPLICABLE HAZCHEM CODE 2YE IERG IATA (Airfreight) UN NUMBER UN PROPER SHIPPING NAME AEROSOLS, FLAMMABLE DANGEROUS GOODS CLASS SUBSIDIARY RISK NONE ALLOCATED PACKING GROUP NONE ALLOCATED IMDG (Seafreight)

7 UN NUMBER UN PROPER SHIPPING NAME AEROSOLS, FLAMMABLE DANGEROUS GOODS CLASS SUBSIDIARY RISK NONE ALLOCATED PACKING GROUP NONE ALLOCATED REGULATORY INFORMATION Product Certifications 381 AICS - yes FF OTHER INFORMATION REASON FOR REISSUE 391 Added/Deleted stock numbers The information in this Material Safety Data Sheet (MSDS) is believed 395 to be correct as of the date of issue. 3M MAKES NO WARRANTY, EXPRESSED 396 OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED WARRANTY, 397 (UNLESS REQUIRED BY LAW) OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR 398 PURPOSE OR COURSE OF PERFORMANCE OR USAGE OF TRADE. User is responsible 399 for determining whether the 3M product is fit for a particular purpose 400 and suitable for user's method of use or application. Given the variety 401 of factors that can affect the use and application of a 3M product, 402 some of which are uniquely within the user's knowledge and control, it 403 is essential that the user evaluates the 3M product to determine 404 whether it is fit for a particular purpose and suitable for user's 405 method of use or application M provides information in electronic form as a service to customers. 408 Due to the remote possibility of electronic transfer may have resulted 409 in errors, omissions or alterations in this information, 3M makes no 410 representations as to its completeness or accuracy. In addition, 411 information obtained from a database may not be as current as the 412 information in the MSDS available directly from 3M M MSDSs are available at FF