SAFETY DATA SHEET Revision n 007 Revision Date 19.07.2018 Pag. no. 1 / 5 DOC MSDS_SPEEDY_WIRE_GEL SAFETY DATA SHEET According to Regulation (EC) 1907/2006 (REACH) Article 31, Annex II as amended. SECTION 1: Identification of the substance/mixture and of the company/undertaking 1.1 Product identifier: Product name: Synonyms, Trade Names: SPEEDY WIRE GEL SPEEDY WIRE GEL 1.2 Relevant identified uses of the substance or mixture and uses advised against: Identified uses: Industrial Lubricant (industrial professional consumption) Uses advised against: None known. 1.3 Details of the supplier of the safety data sheet: Manufacturer: RAYTECH S.r.l. Via Enrico Fermi 11, 13, 17 20019 Settimo Milanese (MI) - ITALIA Telephone: +39 (02) 33500147 Fax: +39 (02) 33500287 e-mail: info@raytech.it Supplier: RAYTECH S.r.l. Via Enrico Fermi 11, 13, 17 I-20019 Settimo Milanese (MI) tel +39 (02) 33500147 fax: +39 (02) 33500287 1.4 Emergency telephone number: +39 (02) 33500147 SECTION 2: Hazards identification 2.1 Classification of the substance or mixture: The product is classified as hazardous under the provisions of Regulation (EC) 1272/2008 (CLP) (and subsequent amendments and Adjustments). The product therefore requires a safety data sheet in accordance with the provisions of Regulation (EC) 1907/2006 and Subsequent changes. Any additional information regarding health and/or environmental risks is provided in section 11 and 12 of this sheet. 2.1.1. Regulation 1272/2008 (CLP) and subsequent amendments and adjustments Classification and indications of danger: Eye Irrit. 2 H319 The full text of Danger (h) is shown in section 16 of the card. 2.2 Label elements. Danger labelling within the meaning of Regulation (EC) 1272/2008 (CLP) and subsequent amendments and adjustments. Hazard pictograms: Indications of danger: Caution: Contains: H319 causes severe ocular irritation P280 Wear Gloves/protective clothing/protect eyes/face P305 + P351 + P338 in case of eye contact rinse thoroughly for several minutes. Remove any contact lenses if it is easy to do so. Continue to rinse. P337 + P313 If eye irritation persists, consult a doctor. Biocompound 60/polydimethylsiloxane Modified, Cocoamidopropilbetaina
Revision n 007 Revision Date 19.07.2017 Pag. no. 2 / 5 DOC MSDS_SPEEDY_WIRE_GEL 2.3 Other hazards: Information not available. SECTION 3: Composition/information on ingredients 3.1. Substances: Irrelevant information. 3.2 Mixtures. Contains: Identification (CLP). Polydimethylsiloxane Amended CAs. 63148-62-9 Ec. Cocoamidopropilbetaina CAS: 147170-44-3 Ec. 931-333-8 Conc. Classification 1272/2008 %. 1-10 eye Irrit. 2 h319 15-25 eye Irrit. 2 h319 SECTION 4: First aid measures 4.1 Description of first aid measures: After eye contact: After swallowing: After inhalation: After skin contact: - 4.2. Main symptoms and effects, both acute and delayed. For symptoms and effects due to the substances contained, see chap. 11. 4.3. Indication of any need to consult a doctor and special treatments immediately. information. SECTION 5: Firefighting measures 5.1 Extinguishing media: Remove any contact lenses. Wash immediately and abundantly with water for at least 30/60 minutes, opening the eyelids well. Consult a doctor immediately. In case of ingestion rinse the mouth and resort to medical examination showing the safety data sheet. Bring the subject to the open air, away from the place of the accident. Suitable extinguishing media: Carbon dioxide, foam, dust and nebulized water. Unsuitable extinguishing media: No one in particular 5.2. Special hazards arising from the substance or mixture. Hazards due to exposure in case of fire. Avoid breathing the combustion gases or explosions. Combustion produces heavy fumes. 5.3. Recommendations for fire extinguishers General Information Cool with water jets the containers to avoid the decomposition of the product and the development of substances potentially hazardous to health. Always wear complete fire protection equipment. Collect the extinguishing water that should not be drained into the sewers. Dispose Equipment Normal fire-fighting clothing, such as an open-circuit compressed air breathing apparatus (en 137), Complete flame retardant (en469), flame retardant Gloves (en 659) and fire brigade Boots (Ho A29 or A30). SECTION 6: Accidental release measures 6.1 Personal precautions, protective equipment and emergency procedures: Wear suitable protective devices (including personal protective equipment as described in Section 8 of the Safety Data sheet) in order to prevent contamination of the skin, eyes and personal clothing. These indications are valid for both the working and emergency operations. 6.2 Environmental Precautions: Prevent the product from penetrating the sewers, in surface waters, in the groundwater. 6.3 Methods and material for containment and cleaning up: Aspirate the spilled product into a suitable container. Evaluate the compatibility of the container to be used with the product, checking the section. Absorb the remaining with inert absorbent material. Adequate ventilation of the place affected by the loss. Check for any incompatibilities for the material of the containers in section 7. The disposal of contaminated material must be carried out in accordance with the provisions of point 13. 6.4. Reference to other sections Any information regarding personal protection and disposal is detailed in sections 8 and 13. SECTION 7: Handling and storage: 7.1 Precautions for safe handling: Ensure an adequate grounding system for plants and people. Avoid contact with eyes and skin. Do not inhale any dust or vapour or mist. Do not eat,
Revision n 007 Revision Date 19.07.2017 Pag. no. 3 / 5 DOC MSDS_SPEEDY_WIRE_GEL drink or smoke during use. Wash your hands after use. Avoid the dispersion of the product in the environment. 7.2 Conditions for safe storage: Store only in the original container. Store in a ventilated place, away from sources of ignition. Keep containers hermetically closed. Keep the product in clearly labelled containers. Avoid overheating. Avoid violent shocks. Keep containers away from any incompatible materials, checking section 10. 7.3 Specific end use(s): Information not available. SECTION 8: Exposure controls/personal protection 8.1. Control parameters information. 8.2. Exposure controls. Given that the use of appropriate technical measures should always have priority over personal protective equipment, ensure good ventilation in the workplace through effective local aspiration. For the choice of personal protective equipment, ask for advice to its suppliers of chemicals. The individual protection devices must bear the ECdeclaration of conformity with the current standards. Foresee emergency shower with visoculare. Hand protection Protect your hands with Category III Working gloves (ref. norm en 374). For the definitive choice of the material of the work gloves must be considered: compatibility, degradation, time of rupture and permeation. In the case of preparations the resistance of the work gloves to the chemical agents must be verified before use as it is not foreseeable. Gloves have a wear time that depends on the duration and the mode of use. Skin protection Wear work clothes with long sleeves and safety footwear for professional use of category III (ref. Directive 89/686/EEC and standard EN ISO 20344). Wash with soap and water after removing the protective clothing. Eyes Protection: It is advisable to wear a visor or protective visor combined with hermetic glasses (ref. Norm en 166). Respiratory protection Not required for normal use. SECTION 9: Physical and chemical properties 9.1 Information on basic physical and chemical properties: Physical State: Gel Color: Transparent Odor: None Olfactory threshold: Ph: Ca.7.0 Melting or freezing point: -10 C Initial boiling point: Ca. 100 C Boiling range: Flash point: > 100 c Evaporation rate: Flammability of solids and gases: Lower flammability limit: Upper flammability limit: Lower explosive limit: Upper Limit explosiveness: Vapour pressure: Vapour density: Relative density: 1.00 kg/l Solubility: Breakdown coefficient:. Auto-ignition temperature: Decomposition temperature: Viscosity: Explosive properties: Unavailable Oxidizing properties: Unavailable 9.2. More info Information not available.
Revision n 007 Revision Date 19.07.2017 Pag. no. 4 / 5 DOC MSDS_SPEEDY_WIRE_GEL SECTION 10: Stability and reactivity 10.1. Reactivity. There are no particular dangers of reaction with other substances under normal conditions of use. 10.2. Chemical stability. The product is stable under normal conditions of use and storage. 10.3. Possibility of dangerous reactions. Hazardous reactions are not foreseeable under normal use and storage conditions. 10.4. Conditions to be avoided. None in particular. However, adhere to the usual precautions in respect of chemical products. 10.5. Incompatible materials. None in particular. 10.6. Hazardous decomposition products. None in particular SECTION 11: Toxicological information 11.1. Information on toxicological effects. In the absence of experimental toxicological data on the product itself, any hazards of the health product have been assessed on the basis of the properties of the substances contained, in accordance with the criteria laid down in the reference legislation for classification. Therefore, consider the concentration of the individual hazardous substances mentioned in sect. 3 to assess the toxicological effects of exposure to the product. SECTION 12: Ecological information 12.1. Toxicity. information 12.2. Persistence and degradation Polydimethylsiloxane Modified, Cocoamidopropilbetaina: easily biodegradable 12.3. bioaccumulation potential. information. 12.4. Mobility in the ground information. 12.5. Results of PBT and VPVB evaluation No 12.6. Other adverse effects. information. SECTION 13: Disposal considerations 13.1 Waste disposal : Reuse if possible. operate according to local and national provisions. Contaminated packaging SECTION 14: Transport information The product is not to be considered hazardous under the provisions in force concerning the transport of Dangerous Goods by road (A.D.R.), by Rail (RID), by sea (IMDG Code) and by Air (IATA). SECTION 15: Regulatory information 15.1. Standards and legislation on health, safety and the environment specific to the substance or mixture. Seveso category: Restrictions relating to the product or substances contained in accordance with Annex XVII Regulation (EC) 1907/2006: Product. Point. 3 Substances in the candidate list (art. 59 reach): No Substances subject to authorisation (annex XIV reach): No Substances subject to export notification Requirement Reg. (EC) 649/2012: No Substances subject to the Rotterdam Convention: Substances subject to the Stockholm Convention: Health checks: Workers exposed to this hazardous health chemical agent must be subjected to health surveillance carried out in accordance with the provisions of art. 41 of Legislative Decree 81 of 9 April 2008 unless the risk to the safety and health of the worker has been assessed as irrelevant, as provided for in art. 224 paragraph 2. SECTION 16: Other information Text of the hazard indications (h) cited in sections 2-3 of the board: Eye Irrit. 2 Ocular irritation, Category 2 H319 causes severe ocular irritation P280 Wear Gloves/protective clothing/protect eyes/face P305 + P351 + P338 in case of eye contact rinse thoroughly for several minutes. Remove any contact lenses if it is easy to do so. Continue to rinse. P337 + P313 If eye irritation persists, consult a doctor. Legend: -ADR: European Agreement for the Transport of dangerous Goods by road -CAS number: Chemical Abstract Service number -EC50: Concentration that gives effect to 50% of the population subject to test -CE number: identification number in esis (European archive of existing substances)
Revision n 007 Revision Date 19.07.2017 Pag. no. 5 / 5 DOC MSDS_SPEEDY_WIRE_GEL -CLP: EC Regulation 1272/2008 -Dnel: Derived level without effect -EMS: Emergency Schedule -GHS: Global Harmonized System for the classification and labelling of chemical products -IATA DGR: Regulations for the transport of Dangerous goods of the International Air Transport Association -IC50: Concentration of immobilization of 50% of the population subject to testing -IMDG: International Maritime Code for the Transport of Dangerous goods -IMO: International Maritime Organization -Index Number: Identification number in CLP annex VI -LC50: Lethal concentration 50% -LD50: Lethal dose 50% -OEL: Occupational exposure level -PBT: Persistent, bioaccumulative and toxic according to reach -PEC: Predictable environmental concentration -PEL: Predictable exposure level -Pnec: Predictable concentration without effects -Reach: EC Regulation 1907/2006 -RID: Regulation for the International Carriage of dangerous Goods by train -TLV: Threshold Limit Value -TLV ceiling: concentration which must not be exceeded at any time of the working exposure. -TWA Stel: Short-term exposure limit -TWA: Average weighted exposure limit -VOC: Volatile organic compound -VPVB: Very persistent and very bioaccumulative according to reach -WGK: Aquatic Hazard Class (Germany). General Bibliography: 1. Directive 1999/45/EC and subsequent amendments 2. Directive 67/548/EEC and subsequent amendments and adjustments 3. Regulation (EC) 1907/2006 of the European Parliament (reach) 4. Regulation (EC) 1272/2008 of the European Parliament (CLP) 5. Regulation (EC) 790/2009 of the European Parliament (the ATP. Clp) 6. Regulation (EC) 453/2010 of the European Parliament 7. Regulation (EC) 286/2011 of the European Parliament (ii ATP. Clp) 8. Regulation (EC) 618/2012 of the European Parliament (iii ATP. Clp) 9. The Merck Index. Ed. 10 10. Handling Chemical Safety 11. Niosh-Registry of toxic effects of chemical substances 12. InRS-Fiche toxicologique 13th Patty-Industrial hygiene and toxicology 14. N.I. Sax-Dangerous properties of industrial materials-7 ed., 1989 15. Echa Agency website Disclaimer: The information contained in this sheet is based on the knowledge available at the date of the latest version. The user must ensure the suitability and completeness of the information in relation to the specific use of the product. You should not interpret this document as a guarantee of any specific product properties. As the use of the product does not fall under our direct control, it is the obligation of the user to observe under his own responsibility the laws and the regulations in force about hygiene and safety. No liability is assumed for improper use. Provide adequate training to personnel using chemical products.