Installation Guideline

Transcription

1 Lindner Metal Ceiling Preparation of cut-outs Standard installation Illustration 1 Index of contents 1. Safety instructions 2 2. Information about ceiling fixtures 2 3. Preparation of cut-out Preparation Circular plate shears Manual plate shears Compass saw 5 Cut-Outs for Metal Ceilings page 1 of 5 Rev.03 MR-PMD-F0AUS

2 1. Safety instructions - The installation has to be carried out with the necessary carefulness so that neither oneself nor another person is endangered by the installation and so that every other kind of damage is avoided - Necessary measures concerning the security on site, e.g. barriers and protective equipment, have to be taken - The national regulations for operational safety have to be regarded - Depending on the kind of tool for the preparation of cut panels resp. cut-outs inside the panel, the respective safety regulations have to be respected (e.g. safety glasses, protective gloves etc. have to be worn)! - The metal ceiling may only be installed by qualified persons with the necessary technical knowledge, training, instructions and qualifications - Changes on the ceiling system or the use of foreign material cause variances of the technical characteristics of the metal ceilings and have to be agreed upon with the manufacturer 2. Information about ceiling fixtures TAIM e.v. November 2003 Any built-in fittings or loads have to be separately suspended or accommodated. The application of any additional loads, fasteners or recesses, cables (sprinklers, built-in lights, speakers, vents etc.) on the ceiling has to be specified by the building designer and taken into account by the installation company responsible. Cut-Outs for Metal Ceilings page 2 of 5 Rev.03 MR-PMD-F0AUS

3 3. Preparation of cut-out 3.1. Preparation Notice: - Please take into consideration to protect the surface of the ceiling panel around the cut-out by means of a self-adhesive cover tape (x)! Material Cover tape Installation process - Mark the centre of the cut-out - Mark the diameter with dividers or a template - Drill a small hole with a diameter of approximately ø 40/50mm in the middle of the cut-out with a hole saw Cut-Outs for Metal Ceilings page 3 of 5 Rev.03 MR-PMD-F0AUS

4 3.2. Circular plate shears Installation process - Position the electric circular plate shears on the small cut-out 3.3. Manual plate shears Installation process - Position the manual plate shears on the small cut-out Cut-Outs for Metal Ceilings page 4 of 5 Rev.03 MR-PMD-F0AUS

5 3.4. Compass saw Installation process - A protective cover tape has to be applied in the area of the cut-out before beginning the installation process - Deposit and fix e.g. a wooden plate with a cut-out ø + 10 mm and a thickness + 5 mm of the height of the metal ceiling panel on the panel This recommendation shall serve as a guideline to the assembler. The application always has to be examined in individual cases due to the fact that no site-related inspection occurred. The details given therein represent the state-of-the-art and shall inform about our products and their field of application. They are given to the best of our knowledge. No responsibility is taken for the correctness of the information given in this guideline. The relevant standards especially DIN EN as well as the TAIM standards shall be considered. Subject to technical alteration in the course of progress. Drawings and Illustrations are illustrative. All rights reserved. Contact: LINDNER AG P. O. Box 1180 D Arnstorf Phone: / Fax: / Info@Lindner-Group.com Homepage: Publisher: Lindner AG/PM Ceilings Bahnhofstraße 29 D Arnstorf Germany Cut-Outs for Metal Ceilings page 5 of 5 Rev.03 MR-PMD-F0AUS