Material Safety Data Sheet

Transcription

1 according to ANSI Z Product code: SS-61M, SS-61M-EU, SS-161M (diluted) Page 1 of 5 SECTION 1: Identification of the substance/mixture and of the company/undertaking Product identifier Further trade names Mycohold Chemical characterization (Mixture) Details of the supplier of the safety data sheet Company name: Street: Place: Telephone: Responsible Department: Emergency telephone number Info Trac Emergency Response: SECTION 2: Hazards identification Route(s) of Entry ELITechGroup Inc., (dba Wescor, Inc.) 37 West 17 South Logan, UT USA +1 (435) Telefax: +1 (435) QA/RA Department Tel.: +1 (435) West 17 South qara_ebs@elitechgroup.com Logan, UT USA Contact your distributor or poison control center in your country. Calls within the USA, phone: Calls outside the USA, phone: (call collect) Customer ID: #914 (NOTE: this number is required when a customer calls into either phone number above). Signs and Symptoms of Exposure Carcinogenicity (NTP): Carcinogenicity (IARC): Carcinogenicity (OSHA): SECTION 3: Composition/information on ingredients Mixtures Hazardous components CAS No. Components Quantity sodium azide <,1 % Further Information Note: This hazard characteristics refer to the properties of pure ingredients, for the identification of the preparation (product), see Section 2 and 15. SECTION 4: First aid measures Description of first aid measures General information In case of accident or if you feel unwell, seek medical advice immediately (show safety data sheet if possible). After inhalation DOC-338D.docx Page 1 of 5 Revision date:

2 according to ANSI Z Product code: SS-61M, SS-61M-EU, SS-161M (diluted) Page 2 of 5 After contact with skin After contact with skin, wash immediately with: Water and soap. In case of skin irritation, seek medical treatment. After contact with eyes Rinse immediately carefully and thoroughly with eye-bath or water. In case of troubles or persistent symptoms, consult an ophthalmologist. After ingestion Rinse mouth thoroughly with water. Let water be swallowed in little sips (dilution effect). Make affected person vomit if conscious. Never give anything by mouth to an unconscious person or a person with cramps. Call a POISON CENTER or doctor/physician. Indication of any immediate medical attention and special treatment needed First Aid, decontamination, treatment of symptoms. SECTION 5: Firefighting measures Extinguishing media Suitable extinguishing media The product itself is not combustible. Special hazards arising from the substance or mixture Can be released in case of fire: Carbon monoxide. Carbon dioxide (CO 2 ). Nitrogen oxides (NOx). Advice for firefighters Wear a self-contained breathing apparatus and chemical resistant suit. Additional information Collect contaminated fire extinguishing water separately. Do not allow entering drains or surface water. SECTION 6: Accidental release measures Personal precautions, protective equipment and emergency procedures Wear personal protection equipment. (Refer to chapter 8) Environmental precautions Dumping into the environment must be prevented. Methods and material for containment and cleaning up Absorb with liquid-binding material (e.g. sand, diatomaceous earth, acid- or universal binding agents). Treat the assimilated material according to the section on waste disposal. SECTION 7: Handling and storage Precautions for safe handling Advice on safe handling Keep container tightly closed. Keep/Store only in original container. Wear personal protection equipment. (Refer to chapter 8) Advice on protection against fire and explosion No special fire protection measures are necessary. Conditions for safe storage, including any incompatibilities Requirements for storage rooms and vessels Unsuitable materials for Container: Base metals and alloys Keep container tightly closed in a cool, well-ventilated place. Advice on storage compatibility Do not store together with: Oxidizing solids. Oxidizing liquids. Explosives. Food and fodder Further information on storage conditions Protect against: UV-radiation/sunlight. Maximum period of storage (time): 24 M DOC-338D.docx Page 2 of 5 Revision date:

3 according to ANSI Z Product code: SS-61M, SS-61M-EU, SS-161M (diluted) Page 3 of 5 SECTION 8: Exposure controls/personal protection Control parameters Exposure limits CAS No. Components ppm mg/m³ fib/cc Category Origin Sodium azide (as NaN3) TWA (8 h) REL Exposure controls Occupational exposure controls - C.3 Ceiling REL Protective and hygiene measures Always close containers tightly after the removal of product. Do not eat, drink, smoke or sneeze at the workplace. Wash hands before breaks and at the end of work. Respiratory protection With correct and proper use, and under normal conditions, breathing protection is not required. Hand protection Eye protection Skin protection Environmental exposure controls SECTION 9: Physical and chemical properties Information on basic physical and chemical properties Form: Color: Odor: liquid colourless odourless ph-value: 5-9 Changes in the physical state Density: Water solubility: ~1 g/cm³ complete miscible Test method SECTION 1: Stability and reactivity Stability: Possibility of Hazardous Reactions: Stable Will not occur Conditions to avoid Keep away from heat. Do not allow to dry. Incompatible materials Acid. Oxidizing agents, strong. Heavy metals. Copper. Hazardous decomposition products Can be released in case of fire: Carbon monoxide. Carbon dioxide (CO 2 ). Nitrogen oxides (NOx). DOC-338D.docx Page 3 of 5 v

4 SECTION 11: Toxicological information Information on toxicological effects according to ANSI Z Product code: SS-61M, SS-61M-EU, SS-161M (diluted) Page 4 of 5 Irritation and corrosivity Irritant effect on the eye: slightly irritant but not relevant for classification. Irritant effect on the skin: slightly irritant but not relevant for classification. Sensitizing effects No evidence for: Sensitization Severe effects after repeated or prolonged exposure NaN3 LOAEL: 5 mg/kg British Industrial Biological Research Association "Toxicity Profiles" BIBRA Information Department, Carshalton Carcinogenic/mutagenic/toxic effects for reproduction NaN3: No evidence for: Carcinogenicity No experimental indications of mutagenicity in-vivo exist. Evidence for: In-vitro mutagenicity Animal experiments indicate reproductive toxicity. SECTION 12: Ecological information Persistence and degradability Product is biodegradable. Bio-accumulative potential No indication of bio-accumulation potential. SECTION 13: Disposal considerations Waste treatment methods Advice on disposal Waste disposal according to official state regulations. Consult the local waste disposal expert about waste disposal. Moreover, national legislation has to be observed! Contaminated packaging Cleaned containers may be recycled. SECTION 14: Transport information US DOT 49 CFR Proper shipping name Not a hazardous material with respect to these transport regulations. && Not controlled under DOT. Land transport (ADR/RID) Other applicable information Not restricted SECTION 15: Regulatory information U.S. Regulations SARA Section 32 Extremely Hazardous Substances (EHS) Sodium azide (Na(N3)), RQ = 1 lbs, TPQ = 5 lbs. Section 313 Toxic Release Chemicals Sodium azide (CAS ). DOC-338D.docx Page 4 of 5 Revision date:

5 according to ANSI Z SECTION 16: Other information NFPA Hazard Ratings Health: Flammability: Reactivity: Unique Hazard: Changes Product code: SS-61M, SS-61M-EU, SS-161M (diluted) Page 5 of 5 Rev 1, Initial release Other data The above information describes exclusively the safety requirements of the product and is based on our present-day knowledge. The information is intended to give you advice about the safe handling of the product named in this safety data sheet, for storage, processing, transport and disposal. The information cannot be transferred to other products. In the case of mixing the product with other products or in the case of processing, the information on this safety data sheet is not necessarily valid for the new made-up material. (The data for the hazardous ingredients were taken respectively from the last version of the sub-contractor's safety data sheet.) DOC-338D.docx Page 5 of 5 Revision date: