SAFETY DATA SHEET SANI-GLIDE. Section: 1. PRODUCT AND COMPANY IDENTIFICATION. Product name : SANI-GLIDE

Transcription

1 Section: 1. PRODUCT AND COMPANY IDENTIFICATION Product name : Other means of identification : Not applicable. Recommended use : Lubricant Restrictions on use : Reserved for industrial and professional use. Product dilution information :.5 % % Company : Ecolab Co. 515 Tomken Road Mississauga, Ontario Canada L4W 2X Emergency health information : (US/Canada), (outside US) Issuing date : 2/9/216 Section: 2. HAZARDS IDENTIFICATION GHS Classification Skin corrosion : Category 1A Serious eye damage : Category 1 Not a hazardous substance or mixture. GHS Label element Hazard pictograms : Signal Word Hazard Statements Precautionary Statements : Danger : Causes severe skin burns and eye damage. : Prevention: Wash skin thoroughly after handling. Wear protective gloves/ protective clothing/ eye protection/ face protection. Response: IF SWALLOWED: rinse mouth. Do NOT induce vomiting.if ON SKIN (or hair): Take off immediately all contaminated clothing. Rinse skin with water.if INHALED: Remove person to fresh air and keep comfortable for breathing. Immediately call a POISON CENTER/doctor.IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Immediately call a POISON CENTER or doctor/ physician. Wash contaminated clothing before reuse. Storage: / 1

2 Store locked up. Disposal: Dispose of contents/ container to an approved waste disposal plant. Precautionary Statements : Prevention: Wash hands thoroughly after handling. Response: Get medical advice/ attention if you feel unwell. Storage: Store in accordance with local regulations. Other hazards : None known. Section: 3. COMPOSITION/INFORMATION ON INGREDIENTS Pure substance/mixture : Mixture Chemical Name CAS-No. Concentration: (%) 2-methylpentane-2,4-diol ethylenediamine tetraacetate Sodium Xylenesulfonate Ortho-phenylphenol Clorophene No hazardous ingredients Section: 4. FIRST AID MEASURES In case of eye contact In case of skin contact If swallowed If inhaled Protection of first-aiders Notes to physician Most important symptoms and effects, both acute and delayed : Rinse immediately with plenty of water, also under the eyelids, for at least 15 minutes. Remove contact lenses, if present and easy to do. Continue rinsing. Get medical attention immediately. : Wash off immediately with plenty of water for at least 15 minutes. Use a mild soap if available. Wash clothing before reuse. Thoroughly clean shoes before reuse. Get medical attention immediately. : Rinse mouth with water. Do NOT induce vomiting. Never give anything by mouth to an unconscious person. Get medical attention immediately. : Remove to fresh air. Treat symptomatically. Get medical attention if symptoms occur. : If potential for exposure exists refer to Section 8 for specific personal protective equipment. : Treat symptomatically. : See Section 11 for more detailed information on health effects and symptoms / 1

3 In case of eye contact In case of skin contact If swallowed If inhaled : Rinse with plenty of water. : Rinse with plenty of water. : Rinse mouth. Get medical attention if symptoms occur. : Get medical attention if symptoms occur. Section: 5. FIREFIGHTING MEASURES Suitable extinguishing media Unsuitable extinguishing media Specific hazards during firefighting Hazardous combustion products Special protective equipment for firefighters Specific extinguishing methods Risk of explosion. : Use extinguishing measures that are appropriate to local circumstances and the surrounding environment. : None known. : Not flammable or combustible. : Decomposition products may include the following materials: Carbon oxides nitrogen oxides (NOx) Sulphur oxides Oxides of phosphorus : Use personal protective equipment. : Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations. In the event of fire and/or explosion do not breathe fumes. : Not available. Section: 6. ACCIDENTAL RELEASE MEASURES Personal precautions, protective equipment and emergency procedures Environmental precautions Methods and materials for containment and cleaning up Personal precautions, protective equipment and : Ensure adequate ventilation. Keep people away from and upwind of spill/leak. Avoid inhalation, ingestion and contact with skin and eyes. When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. Ensure clean-up is conducted by trained personnel only. Refer to protective measures listed in sections 7 and 8. : Do not allow contact with soil, surface or ground water. : Stop leak if safe to do so. Contain spillage, and then collect with noncombustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations (see section 13). Flush away traces with water. For large spills, dike spilled material or otherwise contain material to ensure runoff does not reach a waterway. : Refer to protective measures listed in sections 7 and / 1

4 emergency procedures Environmental precautions Methods and materials for containment and cleaning up : No special environmental precautions required. : Stop leak if safe to do so. Contain spillage, and then collect with noncombustible absorbent material, (e.g. sand, earth, diatomaceous earth, vermiculite) and place in container for disposal according to local / national regulations (see section 13). Flush away traces with water. For large spills, dike spilled material or otherwise contain material to ensure runoff does not reach a waterway. Section: 7. HANDLING AND STORAGE Advice on safe handling Conditions for safe storage : Do not ingest. Do not get in eyes, on skin, or on clothing. Do not breathe dust/fume/gas/mist/vapours/spray. Use only with adequate ventilation. Wash hands thoroughly after handling. : Do not store near acids. Keep out of reach of children. Store in suitable labeled containers. Storage temperature : -1 C to 5 C Advice on safe handling : Wash hands after handling. For personal protection see section 8. Conditions for safe storage : Keep out of reach of children. Store in suitable labeled containers. Section: 8. EXPOSURE CONTROLS/PERSONAL PROTECTION Components with workplace control parameters Components CAS-No. Form of exposure Permissible concentration Basis 2-methylpentane-2,4-diol (c) 25 ppm CAD AB OEL 121 mg/m3 C 25 ppm CAD BC OEL C 25 ppm OEL (QUE) 121 mg/m3 2-methylpentane-2,4-diol Ceiling 25 ppm ACGIH Ceiling 25 ppm 125 mg/m3 NIOSH REL Engineering measures : Effective exhaust ventilation system. Maintain air concentrations below occupational exposure standards. Personal protective equipment Eye protection Hand protection Skin protection : Wear eye protection/face protection. : Wear the following personal protective equipment: Standard glove type. Gloves should be discarded and replaced if there is any indication of degradation or chemical breakthrough. : Personal protective equipment comprising: suitable protective gloves, / 1

5 safety goggles and protective clothing Respiratory protection Hygiene measures Engineering measures : When workers are facing concentrations above the exposure limit they must use appropriate certified respirators. : Handle in accordance with good industrial hygiene and safety practice. Remove and wash contaminated clothing before re-use. Wash face, hands and any exposed skin thoroughly after handling. Provide suitable facilities for quick drenching or flushing of the eyes and body in case of contact or splash hazard. : Good general ventilation should be sufficient to control worker exposure to airborne contaminants. Personal protective equipment Eye protection Hand protection Skin protection Respiratory protection : No special protective equipment required. : No special protective equipment required. : No special protective equipment required. : No personal respiratory protective equipment normally required. Section: 9. PHYSICAL AND CHEMICAL PROPERTIES Appearance : liquid liquid Colour : light brown light brown Odour : slight slight ph : 12., 1 % Flash point Odour Threshold Melting point/freezing point Initial boiling point and boiling range Evaporation rate Flammability (solid, gas) Upper explosion limit Lower explosion limit Vapour pressure Relative vapour density : Not applicable., Does not sustain combustion. : > 1 C Relative density : 1.79 Water solubility Solubility in other solvents Partition coefficient: n- octanol/water Auto-ignition temperature : soluble / 1

6 Thermal decomposition Viscosity, kinematic Explosive properties Oxidizing properties Molecular weight VOC Section: 1. STABILITY AND REACTIVITY Chemical stability Possibility of hazardous reactions Conditions to avoid Incompatible materials Hazardous decomposition products : Stable under normal conditions. : No dangerous reaction known under conditions of normal use. : None known. : Acids Metals : Decomposition products may include the following materials: Carbon oxides nitrogen oxides (NOx) Sulphur oxides Oxides of phosphorus Section: 11. TOXICOLOGICAL INFORMATION Information on likely routes of exposure : Inhalation, Eye contact, Skin contact Potential Health Effects Eyes Skin Ingestion Inhalation Chronic Exposure Eyes Skin Ingestion Inhalation Chronic Exposure : Causes serious eye damage. : Causes severe skin burns. : Causes digestive tract burns. : May cause nose, throat, and lung irritation. Experience with human exposure / 1

7 Eye contact Skin contact Ingestion Inhalation Eye contact Skin contact Ingestion Inhalation : Redness, Pain, Corrosion : Redness, Pain, Corrosion : Corrosion, Abdominal pain : Respiratory irritation, Cough : No symptoms known or expected. : No symptoms known or expected. : No symptoms known or expected. : No symptoms known or expected. Toxicity Acute oral toxicity Acute inhalation toxicity Acute dermal toxicity Skin corrosion/irritation Serious eye damage/eye irritation Respiratory or skin sensitization Carcinogenicity Reproductive effects Germ cell mutagenicity Teratogenicity STOT - single exposure STOT - repeated exposure Aspiration toxicity Components Acute inhalation toxicity : Acute toxicity estimate : > 5, mg/kg : Acute toxicity estimate : > 5, mg/kg : 2-methylpentane-2,4-diol 4 h LC5 rat: > 1.1 mg/l Clorophene 4 h LC5 rat: 19.8 mg/l Section: 12. ECOLOGICAL INFORMATION Ecotoxicity Environmental Effects : Harmful to aquatic life. Product / 1

8 Toxicity to fish Toxicity to daphnia and other aquatic invertebrates Toxicity to algae Components Toxicity to fish : ethylenediamine tetraacetate 96 h LC5 Fish: 121 mg/l Clorophene 96 h LC5 Fish:.238 mg/l Components Toxicity to daphnia and other aquatic invertebrates : 2-methylpentane-2,4-diol 48 h EC5 Daphnia: 2,8 mg/l Ortho-phenylphenol 48 h EC5: 2 mg/l Components Toxicity to algae : Sodium Xylenesulfonate 96 h EC5: 23 mg/l Persistence and degradability no data available Bioaccumulative potential no data available Mobility in soil no data available Other adverse effects no data available Section: 13. DISPOSAL CONSIDERATIONS Disposal methods Disposal considerations Disposal methods Disposal considerations : The product should not be allowed to enter drains, water courses or the soil. Where possible recycling is preferred to disposal or incineration. If recycling is not practicable, dispose of in compliance with local regulations. Dispose of wastes in an approved waste disposal facility. : Dispose of as unused product. Empty containers should be taken to an approved waste handling site for recycling or disposal. Do not reuse empty containers. Dispose of in accordance with local, state, and federal regulations. : Diluted product can be flushed to sanitary sewer. : Dispose of in accordance with local, state, and federal regulations. Section: 14. TRANSPORT INFORMATION / 1

9 The shipper/consignor/sender is responsible to ensure that the packaging, labeling, and markings are in compliance with the selected mode of transport. Land transport (TDG) Not dangerous goods Sea transport (IMDG/IMO) Not dangerous goods Not intended for transport. Section: 15. REGULATORY INFORMATION This product has been classified according to the hazard criteria of the HPR and the SDS contains all of the information required by the HPR. NPRI Components : Ortho-phenylphenol Nitrilotriaceticacid[NTA] Salt The components of this product are reported in the following inventories: United States TSCA Inventory : On TSCA Inventory Canadian Domestic Substances List (DSL) : All components of this product are on the Canadian DSL. Australia. Industrial Chemical (Notification and Assessment) Act : New Zealand. Inventory of Chemicals (NZIoC), as published by ERMA New Zealand : Japan. ENCS - Existing and New Chemical Substances Inventory : Japan. ISHL - Inventory of Chemical Substances (METI) : Korea. Korean Existing Chemicals Inventory (KECI) : Philippines Inventory of Chemicals and Chemical Substances (PICCS) : China Inventory of Existing Chemical Substances : Section: 16. OTHER INFORMATION / 1

10 Health Health Instability Instability NFPA: Flammability HMIS III: HEALTH 3 3 FLAMMABILITY PHYSICAL HAZARD Special hazard. = not significant, 1 =Slight, 2 = Moderate, 3 = High 4 = Extreme, * = Chronic NFPA: Flammability HMIS III: HEALTH FLAMMABILITY PHYSICAL HAZARD Special hazard. = not significant, 1 =Slight, 2 = Moderate, 3 = High 4 = Extreme, * = Chronic Issuing date : 2/9/216 version : 1.2 Prepared by : Regulatory Affairs REVISED INFORMATION: Significant changes to regulatory or health information for this revision is indicated by a bar in the left-hand margin of the SDS. The information provided in this Safety Data Sheet is correct to the best of our knowledge, information and belief at the date of its publication. The information given is designed only as a guidance for safe handling, use, processing, storage, transportation, disposal and release and is not to be considered a warranty or quality specification. The information relates only to the specific material designated and may not be valid for such material used in combination with any other materials or in any process, unless specified in the text / 1