Lean Operations. Copyright 2012 by The McGraw-Hill Companies, Inc. All rights reserved.

Transcription

1 Lean Operations McGraw-Hill/Irwin Copyright 2012 by The McGraw-Hill Companies, Inc. All rights reserved.

2 You should be able to: 1. Explain what is meant by the term lean operations system 2. List each of the goals of a lean system and explain its importance 3. List and briefly describe the building blocks of lean 4. List the benefits of a lean system 5. Outline the considerations important in converting a traditional mode of operations to a lean system 6. Point out some of the obstacles that might be encountered when converting to a lean system 7. Describe value stream mapping Instructor Slides 14-2

3 Lean operation A flexible system of operation that uses considerably less resources than a traditional system Tend to achieve Greater productivity Lower costs Shorter cycle times Higher quality Instructor Slides 14-3

4 The ultimate goal: Achieve a system that matches supply to customer demand; supply is synchronized to meet customer demand in a smooth uninterrupted flow A balanced system One that achieves a smooth, rapid flow of materials and/or work through the system Instructor Slides 14-4

5 Instructor Slides 14-5

6 The degree to which lean s ultimate goal is achieved depends upon how well its supporting goals are achieved: 1. Eliminate disruptions 2. Make the system flexible 3. Eliminate waste, especially excess inventory Instructor Slides 14-6

7 Five personnel/organizational elements that are important for lean systems: Workers as assets Cross-trained workers Continuous improvement Cost accounting Leadership/project management Instructor Slides 14-7

8 Seven elements of manufacturing planning and control (MPC) are particularly important for lean system: 1. Level loading 2. Pull systems 3. Visual systems 4. Limited work-in-process (WIP) 5. Close vendor relationships 6. Reduced transaction processing 7. Preventive maintenance and housekeeping Instructor Slides 14-8

9 Ideal number of kanban cards DT (1 N C where X ) N Total number of containers(1card per container) D planned usage rate of using work center Average waiting time for replenishment of parts plus T average productiontime for a container of parts Policy variable set by management that relectspossibleinefficiency X in the system(the closer to0, the moreefficient the system Capacity of a standard container (should be no more C than 10 percentof daily usage of the part Instructor Slides 14-9

10 Preventive maintenance Maintaining equipment in good operating condition and replacing parts that have a tendency to fail before they actually do fail Housekeeping Maintaining a workplace that is clean and free of unnecessary materials Instructor Slides 14-10

11 1. Make sure top management is committed and that they know what will be required 2. Decide which parts will need the most effort to convert 3. Obtain support and cooperation of workers 4. Begin by trying to reduce setup times while maintaining the current system 5. Gradually convert operations, begin at the end and work backwards 6. Convert suppliers to JIT 7. Prepare for obstacles Instructor Slides 14-11

12 1. Management may not be fully committed or willing to devote the necessary resources to conversion 2. Workers/management may not be cooperative 3. It can be difficult to change the organizational culture to one consistent with the lean philosophy 4. Suppliers may resist Instructor Slides 14-12

13 In service the focus is often on the time needed to perform the service because speed is often the order winner Lean benefits can be achieved in the following ways: Eliminate disruptions Make system flexible Reduce setup and lead times Eliminate waste Minimize WIP Simplify the process Instructor Slides 14-13

14 JIT II: A supplier representative works right in the company s plant, making sure there is an appropriate supply on hand It is often referred to as vendor managed inventory (VMI) Instructor Slides 14-14

15 Be careful to study the requirements and benefits of lean systems before making a decision to convert operations Evaluate strengths and weaknesses of current operations The decision to convert can be sequential Weigh the pros and cons of a lean approach to inventories Supplier management is critical to a lean operation Instructor Slides 14-15