Installing and Using the HAND-HELD BARCODE SCANNER

Transcription

1 Installing and Using the HAND-HELD BARCODE SCANNER VITROS 5600 Integrated System VITROS 3600 Immunodiagnostic System VITROS 5,1 FS Chemistry System VITROS 4600 Chemistry System Pub. No.: J55820EN Purpose: IMPORTANT: Install and use the HAND-HELD BARCODE SCANNER to manually scan sample barcodes and configured quality control barcodes when there is no Lab Information System (LIS) or to scan VITROS MicroTip reagent pack barcodes and VITROS MicroWell reagent pack barcodes during a manual load. THE BARCODE SCANNER CANNOT BE USED TO SCAN BARCODES ON SLIDE CARTRIDGES. Materials required: BARCODE SCANNER with CABLES BARCODE SCANNER STAND BARCODE CONFIGURATION SHEET IMPORTANT: WAIT UNTIL ASSAY PROCESSING COMPLETES BEFORE YOU PERFORM THIS PROCEDURE. 1. Shut down the system. 2. Move the KEYBOARD aside, and then feed the 2 SCANNER CABLES up through the hole in the bottom of the TRAY ARM.

2 3. Disconnect the KEYBOARD CABLE, and then connect each end of the KEYBOARD CABLE to the corresponding SCANNER CABLE. 4. Set the KEYBOARD back in place. 5. Restart the system. 6. From the Main Menu, touch Options & Configurations Configure System PSID. 7. When the system displays the Configure PSID Checkdigit dialog box, note which option or combination of options ( Code 39, Codabar, and/or IL 2 of 5 ) are enabled for Checkdigit. 8. Scan the barcode(s) on the CONFIGURATION SHEET that correspond to selected Check Digit options on your system. The CONFIGURATION SHEET has been included with the BARCODE SCANNER packaging and is also presented below. Each pair of barcodes on the sheet is assigned a number and system dialog screenshot as shown below: 2 Installing and Using the HAND-HELD BARCODE SCANNER Pub No.: J55820EN

3 Checkdigit not enabled Checkdigit enabled The numbers on the CONFIGURATION SHEET correspond to the numbers and descriptions in the following table: Code 39 without checkdigit (Scan both barcodes) Codabar without checkdigit (Scan both barcodes) Interleaved 2 of 5 without checkdigit (Scan both barcodes) Code 39 with checkdigit (Scan both barcodes) Codabar with checkdigit (Scan both barcodes) Interleaved 2 of 5 with checkdigit (Scan both barcodes) Note: Scan from top to bottom if using more than one pair of barcodes. Pub No.: J55820EN Installing and Using the HAND-HELD BARCODE SCANNER 3

4 Here are two examples that show how to use the Configure PSID Checkdigit dialog box and the table of numbers and descriptions to determine which barcodes may be scanned: Example 1 The Code 39 checkbox is checked, but the Codabar and "IL 2 of 5 checkboxes are not checked. In this situation, you can scan the following barcodes: 4 Installing and Using the HAND-HELD BARCODE SCANNER Pub No.: J55820EN

5 Example 2 No checkboxes are checked. In this situation, you can scan the following barcodes: Pub No.: J55820EN Installing and Using the HAND-HELD BARCODE SCANNER 5

6 9. Place the SCANNER STAND where the SCANNER CABLE will not interfere with DOORS, COVERS, or normal system operation. Ortho Clinical Diagnostics 100 Indigo Creek Drive Rochester, NY Pub. No.: J55820EN All trademarks are registered to Ortho-Clinical Diagnostics, Inc. Ortho-Clinical Diagnostics, Inc Installing and Using the HAND-HELD BARCODE SCANNER Pub No.: J55820EN