KALDEWEI PURO INSET BATH WITH EXAFILL SPECIFICATIONS CLEANING RECOMMENDATIONS. Dimensions are nominal measurements only.

Transcription

1 page 1 of Dimensions are nominal measurements only. SPECIFICATIONS Recommended use Material Colour availability Weight Overflow Plug and waste Capacity Fixing Installation Option Domestic, Hotel and Commercial 3.5mm Enamel Steel White (other colour options available) 46 kg HANSGROHE EXAFILL Integrated Bath Filler & Overflow 40mm Pop-up Waste and overflow included 105L Hob Mounted, Built In, Undermounted, or Flush mounted. Sound-deadening pads are a standard inclusion. Leg System # available for easy installation To see the complete KALDEWEI range go to CLEANING RECOMMENDATIONS We recommend the use of soapy water or approved cleaners. This product should not be cleaned with abrasive materials. Damage caused by any improper treatment is not covered by the product warranty. Refer to Warranty Conditions. Disclaimer: Products in this specification manual must by regulation be installed by licensed and registered trade people. The manufacturer/distributor reserves the right to vary specifications or delete models from their range without prior notification. Dimensions are nominal measurements only. Dimensions and set-outs listed are correct at time of publication however the manufacturer/distributor takes no responsibility for printing errors. Tech Page Version 1

2 page 2 of 8 INSTALLATION INSTRUCTIONS Australian Standard 2023/1995 Section 1.5 specifies, A built-in bath shall be provided with a tiling flange or bead not less than 10mm in height. When handling steel enamel baths, care must be taken that they are treated correctly. This applies to their transport, unpacking and installation. Kaldewei recommends that baths be fitted during the final installation and that the bath be covered until all the building work has been completed. This bath has been supplied with sufficient high impact rigid PVC modified grade material to allow, where necessary, for the bath to be flashed along the full length and ends to conform with the Australian standard. This clip on material should be cut to the required lengths, mitred at the corners, and the area where the flashing material and the rim of the bath meet, should be filled with a mould-resistant Sanitary Grade sealant. When the bath is installed, the minimum distance from the outside edge of the flange to the finished edge of the tiles shall be 10mm. The exposed area of the flange shall have continuous fall to the inside of the bath. STUD OR MASONRY WALL TILES BATH OR SHOWER TRAY TILE ADHESIVE FLEXIBLE MASTIC SEALANT PVC TILE TRIM SUPPORT BATTEN

3 AS/NZS 3718 WMKA page 3 of 8 Exa-Bathtub Filler Push-Open with flow limiter 2 without flow limiter (1 MPa = 10 bar = 147 PSI)

4 page 4 of SW 2 mm

5 page 5 of 8 5 EN The drain valve may only be installed in tubs with an overflow opening. EN IMPORTANT! Don t bend the connection hose (not part of delivery). You must follow the manufacturer instructions. There is no guarantee of Hansgrohe for components and their connections produced by third parties.

6 page 6 of 8 Operation Cleaning

7 page 7 of (65x2)

8 page 8 of 8 LEG SYSTEM INSTALLATION INSTRUCTIONS Place the bath with its packaging upside down. Slot the arm straps of the bath cradle (b) onto the lugs (a) on the base of the bath. a b a 3. Push a suitable length of the tensioning belt onto the retaining bolt (a), engage the threaded hook (c) and tighten by hand using the nut on the base. 4. Turn over bath, align with the help of a spirit level by turning the screw and tighten the locknut (d). With the use of the Kaldewei sound insulation set, and provided installation is effected properly, the requirements of DIN 4109/A1 are fulfilled. a c Baths must also be mounted with bath anchors (not included in the scope of delivery). d