BSB41415 Certificate IV in Work Health and Safety. Safety Culture and Compliance. V1.1 Produced 24 February 2016

Transcription

1 BSB41415 Certificate IV in Work Health and Safety Safety Culture and Compliance V1.1 Produced 24 February 2016 Copyright 2016 Compliant Learning Resources. All rights reserved. No part of this publication may be reproduced or distributed in any form or by any means, or stored in a database or retrieval system other than pursuant to the terms of the Copyright Act 1968 (Commonwealth), without the prior written permission of Compliant Learning Resources Assessor Guide 1

2 TABLE OF CONTENTS This is an interactive table of contents if you are viewing this document in Acrobat clicking on a heading will transfer you to that page. If you have this document open in Word you will need to hold down the Control key while clicking for this to work. INTRODUCTION... 4 WHAT IS COMPETENCY BASED ASSESSMENT... 4 THE BASIC PRINCIPLES OF ASSESSING NATIONALLY RECOGNISED TRAINING... 5 THE DIMENSIONS OF COMPETENCY... 6 REASONABLE ADJUSTMENT... 7 THE UNIT OF COMPETENCY... 9 CONTEXT FOR ASSESSMENT ASSESSMENT METHODS RESOURCES REQUIRED FOR ASSESSMENT INSTRUCTIONS TO ASSESSOR INSTRUCTIONS TO STUDENT ASSESSMENT WORKBOOK COVER SHEET WRITTEN QUESTIONS Knowledge Assessment 1 Multiple choice questions Knowledge Assessment 2 Short answer questions ASSESSOR CHECKLIST FEEDBACK Compliant Learning Resources Page 3

3 THE UNIT OF COMPETENCY Each unit of competency can be unbundled to reveal three key assessment components: 1. Performance Evidence - describes the subtasks that make up the element of the unit 2. Knowledge Evidence - describes the knowledge that must be applied in understanding the tasks described in the elements 3. Assessment Condition - describes the environment and conditions that assessments must be conducted under The associated assessment tool in this kit covers all of these components as detailed in the matrix to follow: Assessment Activities Knowledge Assessment 1: Multiple Choice Questions Knowledge Assessment 2: Short Answer Questions Units of Competency Compliant Learning Resources Page 9 BSBWHS402 BSBWHS403 BSBWHS404 BSBWHS405 BSBWHS406 This assessment addresses the following units of competency from BSB Certificate IV in Work Health and Safety: BSBWHS402 Assist with compliance with WHS laws 1. Assist with determining the legal framework for WHS in the workplace 2. Assist with providing advice on WHS compliance 3. Assist with WHS legislation compliance measures

4 BSBWHS403 Contribute to implementing and maintaining WHS consultation and participation processes 1. Identify individuals and parties involved in WHS consultation and participation processes 2. Contribute to WHS consultation and participation processes 3. Contribute to processes for communicating and sharing WHS information and data 4. Contribute to identifying and meeting training requirements for effective WHS consultation and participation 5. Contribute to improving WHS consultation and participation processes BSBWHS404 Contribute to WHS hazard identification, risk assessment and risk control 1. Access information to identify hazards and assess and control risks 2. Contribute to compliance and workplace requirements 3. Contribute to workplace hazard identification 4. Contribute to WHS risk assessment 5. Contribute to the development, implementation and evaluation of risk control BSBWHS405 Contribute to implementing and maintaining WHS management systems 1. Contribute to developing and promoting WHS policy 2. Contribute to WHSMS planning 3. Contribute to implementing the WHSMS plan 4. Contribute to evaluating WHS performance 5. Contribute to reviewing and improving the WHSMS BSBWHS406 Assist with responding to incidents 1. Assist with identifying legislative and other requirements investigation 2. Assist with implementing initial incident response procedures 3. Assist with collecting WHS information and data relevant to an Page 10 Compliant Learning Resources

5 4. Assist incident investigations 5. Assist in implementing recommended measures and actions arising from investigations CONTEXT FOR ASSESSMENT To complete the knowledge assessments in this workbook, students are required to have access to their learning materials, the internet and resources relevant to the Work Health and Safety legislation. This may be completed wholly at the student s home, or chosen place of study. ASSESSMENT METHODS There are four assessment (4) workbooks for this course. This is Workbook 1. Workbook 1 contains the written questions assessments: A set of generic and workplace questions testing the student s general knowledge and understanding of the general theory behind this unit. RESOURCES REQUIRED FOR ASSESSMENT To complete the assessments in this workbook, the candidates will need access to: Computer with internet access, MS Word, Adobe Acrobat Reader Online resources or hard copy of documents relating to Work Health and Safety legislation Compliant Learning Resources Page 11

6 WRITTEN QUESTIONS Knowledge Assessment 1 Multiple choice questions Guidance: For the purpose of this assessment, you may refer to your Learner Guide 1 and the WHS Legislation. 1. Match the following duties to the correct individuals and parties as indicated in the relevant WHS legislation: a) Officers b) PCBU c) Other persons at the workplace d) Workers Mapping: BSBWHS402 PC1.3(k), KE1 (p) BSBWHS404 PC2.3, PE 5, BSBWHS405 PC2.1(p) Assessment ID: Learner guide 1 pp Marking guide: c/d c/d a b a) Take reasonable care that their acts or omissions do not affect the health and safety of other persons. b) Comply with any reasonable instruction from the person conducting a business or undertaking (PCBU) so far as you are reasonably able. c) Acquire and keep up to date knowledge of work health and safety matters. d) The provision and maintenance of a work environment without risks to health and safety. Page 14 Compliant Learning Resources

7 6. Match the following terms with their correct definition by writing the correct letter on the left. Mapping: BSBWHS404 KE 2 Assessment ID: Learner guide 1 pp. 12 Marking guide: a c b Safety Hazard Risk a) state in which the risk of harm (to persons) or damage is limited to an acceptable level b) the likelihood and consequence of that injury or harm occurring c) anything that has the potential to cause harm or injury to people or equipment 7. Which of the following methods are used to assess WHS compliance? Select all that apply. Mapping: BSBWHS402 KE5.1, PC3.1(k) Assessment ID: Learner guide 1 pp. 41 Marking guide: a) Court proceedings b) Infringement notices c) Developing safety policy d) Regular audit e) Checking record completion Compliant Learning Resources Page 19

8 Knowledge Assessment 2 Short answer questions 1. List at least two (2) obligations of the following parties relating to hazardous chemicals according to legislation. Guidance: For the purpose of this assessment, refer to the WHS Regulations relevant to your State/Territory. Mapping: BSBWHS402 KE1 (p), PC 1.3 (k) Assessment ID: Learner guide pp. n/a Source: WHS Regulations 2011 Marking guide: Student must be able to provide at least two obligations of each of the following parties as outlined in the WHS Regulation which applies to their specific State/Territory. Student wordings may vary. Sample answers include but are not limited to the following: 1.1 PCBU Must ensure that a hazardous chemical used, handled or stored at the workplace is correctly labelled in accordance with regulation Must ensure that a hazardous chemical is correctly labelled Must ensure that a container labelled for a hazardous chemical is used only for the use, handling or storage of the hazardous chemical Must ensure, so far as is reasonably practicable, that a hazardous chemical in pipe work is identified by a label, sign or another way on or near the pipe work 1.2 Manufacturers and importers Determine whether the substance, mixture or article is hazardous chemical Ensure that the hazardous chemical is correctly classified Must prepare a safety data sheet for the hazardous chemical Must ensure that the hazardous chemical is correctly packed Must give an emergency service worker the chemical identity of an ingredient of the hazardous chemical as soon as practicable after the worker requests it Must give the registered medical practitioner the chemical identity of an ingredient of the hazardous chemical as soon as practicable 1.3 Suppliers Must not supply the hazardous chemical for use at another workplace if the hazardous chemical is not correctly packed Must not supply the hazardous chemical for use at another workplace if the hazardous chemical is not correctly labelled Page 22 Compliant Learning Resources

9 ASSESSOR CHECKLIST When you have completed this assessing the assessment workbook, review the candidate s assessment against the checklist below: The candidate has completed all the assessments in the workbook: Knowledge Questions 1 Knowledge Questions 2 IMPORTANT REMINDER Candidates must achieve a satisfactory result to ALL assessment tasks to be awarded COMPETENT for the units relevant to this cluster. To award the candidate competent in the units relevant to this subject, the candidate must successfully complete all the requirements listed above according to the prescribed benchmarks. Page 26 Compliant Learning Resources

10 FEEDBACK Well done for completing the delivery of this workbook. We hope that your training and assessment experience using our resources has been a seamless and fruitful journey. At Compliant Learning Resources we continually strive to improve our training and assessment resources and heighten the training and assessment experience for you. One way we do this is by seeking feedback. Your experience is important to us and we are very keen to hear any suggestions or complaints you may have. Click on the button below to let us know what you think of us and our learning resources. CLICK HERE End of Document Compliant Learning Resources Page 27